Difference between revisions of "How to setup the IDC10 cable"
From IGEP - ISEE Wiki
Manel Caro (talk | contribs) |
Manel Caro (talk | contribs) |
||
| Line 1: | Line 1: | ||
= How to Prepare the IDC10 to DB9 Cable for use it with a USB232 Serial Conversor on IGEPv2-RC Series = | = How to Prepare the IDC10 to DB9 Cable for use it with a USB232 Serial Conversor on IGEPv2-RC Series = | ||
| − | == Necessary Material == | + | == Necessary Material == |
#IDC10 to DB9 Cable. | #IDC10 to DB9 Cable. | ||
#Cutter. | #Cutter. | ||
| − | #Scissors.<br> | + | #Scissors.<br> |
| + | #'''[http://www.igep.es/public_docs/IGEPv2/HW_User_Manuals/MAN-PR-IGEP.0020.HW_USER_MANUAL.pdf IGEPv2 Hardware Reference Manual]'''. | ||
[[Image:DSC 0164.JPG]] | [[Image:DSC 0164.JPG]] | ||
| − | <br> | + | <br> |
== Procedure == | == Procedure == | ||
Revision as of 19:03, 12 November 2010
Contents
How to Prepare the IDC10 to DB9 Cable for use it with a USB232 Serial Conversor on IGEPv2-RC Series
Necessary Material
- IDC10 to DB9 Cable.
- Cutter.
- Scissors.
- IGEPv2 Hardware Reference Manual.
Procedure
The first step it's to separate the wires 5 and 6 for it and start from the read mark (the red mark it's the first) you should count 5 wires the you should do a cut between wires 5 and 6.
This is the result for the cut between wire 5 and 6.
Now you must cut the unnecessary wires (wires 6 to 10).
And the final result.
Now you're ready for test the result:
Serial Port Setup
You can use minicom, putty or several programs for connect to the serial debug port. The right Serial Port Configuration it's: 115200 - 8N1 without hardware or software flow control.
