Difference between revisions of "How to setup the IDC10 cable"
From IGEP - ISEE Wiki
Manel Caro (talk | contribs) |
Manel Caro (talk | contribs) |
||
| Line 53: | Line 53: | ||
== Serial Port Setup == | == Serial Port Setup == | ||
| − | You can use minicom, putty or | + | You can use minicom, putty or several programs for connect to the serial debug port. The right Serial Port Configuration it's: 115200 - 8N1 without hardware or software flow control. |
Revision as of 19:02, 12 November 2010
Contents
How to Prepare the IDC10 to DB9 Cable for use it with a USB232 Serial Conversor on IGEPv2-RC Series
Necessary Material
- IDC10 to DB9 Cable.
- Cutter.
- Scissors.
Procedure
The first step it's to separate the wires 5 and 6 for it and start from the read mark (the red mark it's the first) you should count 5 wires the you should do a cut between wires 5 and 6.
This is the result for the cut between wire 5 and 6.
Now you must cut the unnecessary wires (wires 6 to 10).
And the final result.
Now you're ready for test the result:
Serial Port Setup
You can use minicom, putty or several programs for connect to the serial debug port. The right Serial Port Configuration it's: 115200 - 8N1 without hardware or software flow control.
