Difference between revisions of "How to setup the IDC10 cable"
From IGEP - ISEE Wiki
(→How to Prepare the IDC10 to DB9 Cable for use it with a USB232 Serial Conversor on IGEPv2-RC Series) |
m (→Necessary Material) |
||
| Line 6: | Line 6: | ||
#Cutter. | #Cutter. | ||
#Scissors.<br> | #Scissors.<br> | ||
| − | #'''[http://www. | + | #'''[http://www.isee.biz/component/zoo/item/igepv2-hardware-reference-manual IGEPv2 Hardware Reference Manual]'''. |
[[Image:DSC 0164.JPG]] | [[Image:DSC 0164.JPG]] | ||
Revision as of 16:19, 27 August 2012
Contents
How to Prepare the IDC10 to DB9 Cable for use it with a USB232 Serial Conversor on IGEPv2-RC Series
Necessary Material
- IDC10 to DB9 Cable.
- Cutter.
- Scissors.
- IGEPv2 Hardware Reference Manual.
Procedure
The first step it's to separate the wires 5 and 6 for it you should start count from the red mark (the red mark it's the first, wire = 1) you should count 5 wires then you should do a cut between wires 5 and 6.
This is the result for the cut between wire 5 and 6.
Now you must cut the unnecessary wires (wires 6 to 10).
And the final result.
Now you're ready for test the result:
Serial Port Setup
You can use minicom, putty or several programs for connect to the debug serial port .
Cable Type
If your terminal not prints out text check the pinouts of your serial cable. In most cases you need a 'null modem cable'.
