Difference between revisions of "How to setup the IDC10 cable"
From IGEP - ISEE Wiki
m |
|||
Line 55: | Line 55: | ||
You can use minicom, putty or several programs for connect to the [[Using serial debug port to communicate|debug serial port]] . | You can use minicom, putty or several programs for connect to the [[Using serial debug port to communicate|debug serial port]] . | ||
− | + | ||
− | |||
[[Category:How to forge]] | [[Category:How to forge]] | ||
[[Category:UART]] | [[Category:UART]] |
Revision as of 13:15, 26 April 2012
Contents
How to Prepare the IDC10 to DB9 Cable for use it with a USB232 Serial Conversor on IGEPv2-RC Series
Necessary Material
- IDC10 to DB9 Cable.
- Cutter.
- Scissors.
- IGEPv2 Hardware Reference Manual.
Procedure
The first step it's to separate the wires 5 and 6 for it you should start count from the red mark (the red mark it's the first, wire = 1) you should count 5 wires then you should do a cut between wires 5 and 6.
This is the result for the cut between wire 5 and 6.
Now you must cut the unnecessary wires (wires 6 to 10).
And the final result.
Now you're ready for test the result:
Serial Port Setup
You can use minicom, putty or several programs for connect to the debug serial port .