4,199
edits
Changes
From IGEP - ISEE Wiki
m
no edit summary
Now you have a booted board with latest firmware running from MicroSD card, you can write the firmware to the flash memory.
Enter to the IGEP Processor Board using root as login name and an empty password, enter to the /opt/firmware and run the ./igep-flash script <pre>igep-flash --image /opt/firmware/demo-image-sato-igep00x0.tar.bz</pre> When finish, power off your board, unplug the micro-SD card and power on the board. That's all, enjoy the new firmware running from the flash memory. NOTE: You can speed up flash procedure. By default the flash script runs the nandtest command to mark bad blocks, this can take a long time and in most cases is not necessary, you can speed up the flash procedure running the script as follows:
'''NOTE:''' You can speed up flash procedure. By default the flash script runs the nandtest command to mark bad blocks, this can take a long time and in most cases is not necessary, you can speed up the flash procedure running the script as follows:
<pre>igep-flash --image /opt/firmware/demo-image-sato-igep00x0.tar.bz --skip-nandtest </pre>
