4,199
edits
Changes
From IGEP - ISEE Wiki
m
cd <pre>igep-flash --image /opt/firmware /demo-image-sato-igep00x0.tar.bz</flash.shpre>
no edit summary
Enter to the IGEP Processor Board using root as login name and an empty password, enter to the /opt/firmware and run the ./flash script
When finish, power off your board, unplug the MicroSD micro-SD card and reboot power on the board. That's all, enjoy the new firmware running from the flash memory. NOTE: You can speed up flash procedure. By default the flash script runs the nandtest command to mark bad blocks, this can take a long time and in most cases is not necessary, you can speed up the flash procedure running the script as follows: <pre>igep-flash --image /opt/firmware/demo-image-sato-igep00x0.tar.bz --skip-nandtest </pre>
= Firmware releases =
