What can I do with IGEP RADAR SENSOR ORION
From IGEP - ISEE Wiki
|
|
Interfacing with the sensor
You can control the sensor and get IF signal directly or through included ADC by means of different expansion connectors.
The included DDS modulator can be programmed with a set of different modulation ramps through the SPI link available on the expansion connectors.
The IF signal can be obtained directly in analog format or already sampled by the included ADC through the same SPI link used to program the DDS modulator.
The following paragraphs give you the pin-out of the different expansion connectors:
Expansion connector-I
Expansion connector JC1 is intended for control and monitoring of internal radar sensor ORION signals.
JC1 pin-out
NOMENCLATURE
Function names marked with gray shading (1) indicates that are available only on demand
PIN: PIN NUMBER OF THE CONNECTOR. SUBINDEX MEANING:
o PW: Power Line
o DIG: CMOS DIGITAL SIGNAL PORT 1V8 LOGIC LEVELS
o DIG3: CMOS DIGITAL SIGNAL PORT 3V3 LOGIC LEVELS
o DIG5: CMOS DIGITAL SIGNAL PORT 5V LOGIC LEVELS
o ANA: ANALOG PORT
o NC: PIN NOT CONNECTED<span /><span lang="EN-US" style="mso-bidi-font-family: TimesNewRoman" />
o (L): ACTIVE LOW LEVEL
o (H): ACTIVE HIGH LEVEL
LEVEL: IS THE NOMINAL VOLTAGE LEVEL
MODE 0: IS THE MODE 0 function pin name of OMAP microcontroller
MAX: IS THE ABSOLUTE MAXIMUM ALLOWED VOLTAGE LEVEL ON THIS PIN (PERMANENT DAMAGE IF HIGHER VOLTAGE)
FUNCTION: DESCRIPTION OF PIN SIGNAL
o (1): ISEE INTERNAL USE TEST PIN. AVAILABLE ONLY ON DEMAND<span lang="EN-US" style="mso-bidi-font-family: TimesNewRoman" />
o (2): INPUT when power supply is applied to radar board. OUTPUT in other case.
IGEPv2 Expansion
A single expansion connector, JC2, is enough to adapt IGEPv2 processor board to the radar sensor ORION.
JC2 pin-out
IGEP COM MODULE Expansion
2 expansion connectors are needed to interface radar sensor ORION with processor board IGEP COM MODULE: JC3 & JC4
JC3 pin-out
Expansion connector JC4
Applications
You can see a complete list of applications of the radar sensor ORION combined with a processor board on this link: RADAR APPLICATIONS
You have successfully completed this chapter of the guide.
|
|
If you have any question, don't ask to ask at the IGEP Community Forum or the IGEP Community Chat | 
|
