1,381
edits
Changes
From IGEP - ISEE Wiki
no edit summary
<br>
[[Image:IGEP module.jpg|center]]
== Power the module without use the OTG and without baseboard. ==
<span style="background-color: rgb(51, 102, 255);"><span style="color: rgb(255, 255, 255);">'''WARNING: You can damange the module using this information, modify, manipulate or follow this how to can end with the lose of all warranty.'''</span></span>
5V Input DC pad in the below image you can find the 5VDC pad. You must connect the positive (+) 5 VDC here.
[[Image:IGEP0030-GND-Image(2).jpg|thumb|center]]Connect your (-) GND to this pad.
Now you can power the module using these (VCC, GND) pads.
== Use The OTG as Host with the Module in Standalone. ==
The module has a 0 Ohms resistor for protect the 5VDC regulator that acts when you plug the OTG cable for act has HOST.
You must remove this resistor if you wish use the OTG as host in standalone, if you wish use a baseboard then you must install it again.
You must desolder the resistor R200 that it's in the red circle in the below image.
[[Image:R200-Protection-Resistor.jpg|thumb|center]]
== Final Result ==
You can power the board from your 5VDC prefered power supply and use it as OTG Host for your gadgets ...
In this case I used a IGEP Module without WIFI/BT module and use it with a external WIFI dongle ...
[[Image:IGEP_Module_standalone_gadgetIGEP Module standalone gadget.JPG|thumb|center]] [[Category:How_to_forge]][[Category:Hardware]]
