Difference between revisions of "How to setup Murata LBEH59XUHC WiFi/BT module"
From IGEP - ISEE Wiki
| Line 1: | Line 1: | ||
| − | |||
== Bluetooth == | == Bluetooth == | ||
Firmware : TIInit_7.6.15.bts (from https://github.com/TI-ECS/bt-firmware) | Firmware : TIInit_7.6.15.bts (from https://github.com/TI-ECS/bt-firmware) | ||
| − | + | == Basic usage == | |
# BT_EN | # BT_EN | ||
| Line 17: | Line 16: | ||
hcitool -i hci0 scan | hcitool -i hci0 scan | ||
| + | == Wireless == | ||
| + | |||
| + | Firmware : ti-connectivity (from linux-firmware repository) | ||
| − | == wl12xx debug == | + | === wl12xx debug === |
Make sure that DYNAMIC DEBUG is enabled in your kernel configuration. | Make sure that DYNAMIC DEBUG is enabled in your kernel configuration. | ||
Revision as of 13:59, 7 October 2013
Bluetooth
Firmware : TIInit_7.6.15.bts (from https://github.com/TI-ECS/bt-firmware)
Basic usage
# BT_EN echo 0 > /sys/class/gpio/gpio142/value sleep 1 echo 1 > /sys/class/gpio/gpio142/value # Attach to bluetooth device hciattach -s 115200 /dev/ttyO4 texas 3000000 # Setup interface and scan for devices hciconfig hci0 up hciconfig hci0 piscan hcitool -i hci0 scan
Wireless
Firmware : ti-connectivity (from linux-firmware repository)
wl12xx debug
Make sure that DYNAMIC DEBUG is enabled in your kernel configuration.
CONFIG_DYNAMIC_DEBUG=y
echo 8 > /proc/sys/kernel/printk echo 0x8800 > /sys/module/wlcore/parameters/debug_level echo -n 'module cfg80211 +p' > /sys/kernel/debug/dynamic_debug/control echo -n 'module mac80211 +p' > /sys/kernel/debug/dynamic_debug/control echo -n 'module wl12xx +p' > /sys/kernel/debug/dynamic_debug/control
