Difference between revisions of "How to setup Murata LBEH59XUHC WiFi/BT module"
From IGEP - ISEE Wiki
(→wl12xx debug) |
|||
| Line 16: | Line 16: | ||
CONFIG_DYNAMIC_DEBUG=y | CONFIG_DYNAMIC_DEBUG=y | ||
| + | <pre> | ||
| + | echo 8 > /proc/sys/kernel/printk | ||
| + | echo 0x8800 > /sys/module/wlcore/parameters/debug_level | ||
| + | echo -n 'module cfg80211 +p' > /sys/kernel/debug/dynamic_debug/control | ||
| + | echo -n 'module mac80211 +p' > /sys/kernel/debug/dynamic_debug/control | ||
| + | echo -n 'module wl12xx +p' > /sys/kernel/debug/dynamic_debug/control | ||
| + | </pre> | ||
== Links == | == Links == | ||
Revision as of 14:00, 2 October 2013
Ad-hoc
# Setting the operation mode to ad-hoc. iw dev wlan0 set type ibss # Setting wlan0 interface up. ip link set wlan0 up # Setting ESSID and frequency (2427MHz - channel 4) iw dev wlan0 ibss join "MyAd-Hoc" 2427 # Setting ip address ip addr add 192.168.6.1/24 dev wlan0
wl12xx debug
Make sure that DYNAMIC DEBUG is enabled in your kernel configuration.
CONFIG_DYNAMIC_DEBUG=y
echo 8 > /proc/sys/kernel/printk echo 0x8800 > /sys/module/wlcore/parameters/debug_level echo -n 'module cfg80211 +p' > /sys/kernel/debug/dynamic_debug/control echo -n 'module mac80211 +p' > /sys/kernel/debug/dynamic_debug/control echo -n 'module wl12xx +p' > /sys/kernel/debug/dynamic_debug/control
