Difference between revisions of "How to create a SD-card with the latest software image"
From IGEP - ISEE Wiki
m (Created page with '<section begin=IGEPv2 /> <section begin=IGEP_COM_MODULE /> <section begin=IGEP_COM_PROTON /> {{Message/Information Message|title=TITLE|message=This How-To was tested with an Ubun…') |
(No difference)
|
Revision as of 16:01, 2 May 2012
This How-To was tested with an Ubuntu 10.04 host machine, but most of the contents are valid also for other GNU/Linux distributions.
There is no guarantee that this will work on other distributions. |
Start session in a Linux PC. The first thing you'll do is download latest firwmare from the ISEE site.
Download it from the Software / IGEP Firmware section of your board:
http://www.isee.biz/products/processor-boards/igepv2-board for IGEPv2
http://www.isee.biz/products/processor-boards/igep-com-module for IGEP COM MODULE
http://www.isee.biz/products/processor-boards/igep-com-proton for IGEP COM PROTON
Next, open a Terminal to untar the firmware you have just donwloaded and enter to the directory:
tar xzf poky-firmware-3.3.1-11.tar.gz cd poky-firmware-3.3.1-11/
Insert your SD card into the host machine (the machine you downloaded the firmware), and run following command
./poky-media-create --mmc [device] --binary poky-image-sato-igep00x0-[timestamp].tar.gz --machine [machine]
where:
- [device] is the SD card device name, for example: /dev/sdb
- [timestamp] is the timestamp of tar.gz file
- [machine] is the machine name, options are
- igep0020
- igep0030
- igep0032
Finally plug the MicroSD card into IGEP Processor Board and power up your board.