Linux Kernel 2.6.37.y - Wilink 8
From IGEP - ISEE Wiki
Introduction
This article is for specific 2.6.37.y Linux kernel branch serie.
It is interesting read The Linux kernel article previously.
On this 2.6.37.y version, supported IGEP Processor Boards are:
- IGEP COM MODULE / ELECTRON (IGEP0030)
The currently supported IGEP Expansion Boards are as follows:
- IGEP PARIS / BERLIN (BASE0010)
Binaries: latest stable kernel version is: 2.6.37-9 (20140522)
Platform | Sources | zImage binary | Modules binaries |
---|---|---|---|
IGEP00x0 | 2.6.37-9 (md5sum) | zImage-2.6.37-9.bin (md5sum) | modules-2.6.37-9 (md5sum) |
Build kernel from sources
Download the latest stable version sources and follow next steps:
wget http://downloads.isee.biz/pub/releases/linux_kernel/v2.6.37-9/linux-omap-2.6.37-9.tar.gz tar xzf linux-omap-2.6.37-9.tar.gz cd [kernel version]
Also, it could download from GIT Repositories (http://git.isee.biz/) and test the last unstable version at your own risk (see "Linux mainline tree (development)" chapter in The Linux kernel)
Configure Linux kernel for IGEP devices. IGEP is ARM architecture based device. A generic configuration is provided for all IGEP machines, and can be used as the default by
make ARCH=arm igep00x0_defconfig
Then build the kernel and kernel modules. The result will be an zImage file in arch/arm/boot directory. Execute:
make ARCH=arm CROSS_COMPILE=[your cross compiler] zImage modules
For example, if you are using IGEP SDK Toolchain (How to setup a cross compiler) then you should execute following cmdline:
make ARCH=arm CROSS_COMPILE=arm-poky-linux-gnueabi- zImage modules
You can install the kernel modules to your target rootfs
make ARCH=arm CROSS_COMPILE=[your cross compiler] INSTALL_MOD_PATH=[path to your target rootfs] modules_install
Kernel Parameters
This chapter describes some kernel command line parameters you can pass to the kernel during system startup. They also depend on the presence of the hardware with which they are associated.