0
edits
Changes
From IGEP - ISEE Wiki
m
Now you have a booted board with latest firmware running ''(from MicroSD card, you can write the firmware [[How to flash the flash memory. latest software image]])''
Enter to the IGEP Processor Board using root as login name and an empty password, enter to the /opt/firmware and run the igep-flash script <pre>igep-flash --image /opt/firmware/demo-image-sato-igep00x0.tar.bz</pre> When finish, power off your board, unplug the micro-SD card and power on the board. That's all, enjoy the new firmware running from the flash memory. '''NOTE{{:''' You can speed up flash procedure. By default the flash script runs the nandtest command How to mark bad blocks, this can take a long time and in most cases is not necessary, you can speed up the flash procedure running the script as follows: <pre>igep-flash --image /opt/firmware/demo-latest software image-sato-igep00x0.tar.bz --skip-nandtest </pre>}}
added how to flash the latest software image
= How to flash the latest software image =
[[Category:Software]] [[Category:Boot_loaders]] [[Category:Linux_Kernel]] [[Category:Software_distributions]]
