Difference between revisions of "What can I do with IGEP SMARC iMX6"
From IGEP - ISEE Wiki
| Line 58: | Line 58: | ||
== How to use UART (RS485) == | == How to use UART (RS485) == | ||
| − | + | '''under construction''' | |
== CAN BUS == | == CAN BUS == | ||
Revision as of 09:07, 18 May 2016
|
|
Overview
This is the 2/3 chapter of the Getting Started with IGEP SMARC iMX6 Tutorial Guide.
In this second chapter, we will learn some basics tasks. Upon completion, you will be ready to continue with chapter 3/3 that explains more advanced tasks.
Contents
What can I do
You must logged in the board.
Handle the GPIO-LEDS
The board has two user bicolor (green/red) leds available that can be controlled. In its simplest form, you can control of LEDs from userspace. LEDs appear in /sys/class/leds/ and you can turn on and off with following commands:
$ echo 1 > /sys/class/leds/igep\:red\:led1/brightness $ echo 1 > /sys/class/leds/igep\:red\:led0/brightness $ echo 0 > /sys/class/leds/igep\:red\:led1/brightness $ echo 0 > /sys/class/leds/igep\:red\:led0/brightness
$ echo 1 > /sys/class/leds/igep\:green\:led1/brightness $ echo 1 > /sys/class/leds/igep\:green\:led0/brightness $ echo 0 > /sys/class/leds/igep\:green\:led1/brightness $ echo 0 > /sys/class/leds/igep\:green\:led0/brightness
The base has two user (red/blue). Can't use them in the same time.
$ echo 1 > /sys/class/leds/base\:blue\:led0/brightness $ echo 1 > /sys/class/leds/base\:red\:led0/brightness $ echo 0 > /sys/class/leds/base\:blue\:led0/brightness $ echo 0 > /sys/class/leds/base\:red\:led0/brightness
CAN BUS
under construction
How to use UART (RS485)
under construction
CAN BUS
under construction
Audio
under construction
Boot SATA
under construction
Boot emmc
under construction
Install firmware emmc
under construction
EEPROM
under construction
SPINOR
under construction
IO expansion
under construction
wifi
under construction
HDMI resolution
under construction
modem USB
under construction
You have successfully completed this chapter of the guide.
|
|
If you have any question, don't ask to ask at the IGEP Community Forum or the IGEP Community Chat | 
|
