646
edits
Changes
no edit summary
You may now plug the Ethernet cable into the 10/100 Ethernet jack of the IGEPv2 board of the radar to get network access. The default firmware configures the Ethernet device with static ip address (192.168.2.232). Start your PC and plug the Ethernet cable to it.
== Source Power ==
Now, before you apply the source power to the radar, ensure the equipment is fixed over your desk and the cables do not move the radar. Once the radar is fixed you can power it through any of its power connectors: J200 on IGEPv2 board or JP1 on ORION board. Remember you can power the radar through any of both connectors but never apply power to both at the same time. [[Image:RADAR_ON_TABLE_SET_UPs.jpg]]
== Wait few minutes ==