= Getting started =
The following video illustrates Please follow the getting started processnext steps as indicated. You will see how to connect some peripherals and power up could change later the board.way you use the radar but it is very important you follow these instructions at least once for the first time:
== Monitor Place the Radar on a stable surface ==
The Place the radar over your desk and oriented with the ORION board will connect to (antenna) facing a wall of your DVI monitor via its HDMI connectoroffice with nothing in between. You can use a HDMI/DVI-D cable to connect A distance of about 3 meters between the board to radar and the monitor. Your monitor should wall would be able good to support 1024 x 768 @ 60 Hz, which is the default resolution used by make the firmwarefirst measurement.
If your monitor doesn't have a DVI-D input, you can also use a HDMI input using a HDMI/HDMI cable, in that case you should [[How_do_I_edit_my_kernel_command_line | edit the kernel cmdline parameters]] and replace :
omapfb.mode=dvi:1280x720MR-16@60
for this one :
omapfb.mode=dvi:hd720-16@60
== Network ==
You may now plug the Ethernet cable into the 10/100 Ethernet jack of the IGEPv2 board of the radar to get network access. The default firmware configures the Ethernet device with static ip address (192.168.52.1232).
== Keyboard/Mouse ==