4,199
edits
Changes
From IGEP - ISEE Wiki
no edit summary
= Notes =
Read [[Mux configuration|this page]] before use this wiki.<br>
= Overview =
This wiki explained more detailed how-to configure mux<br>
= Disable Peripherals =
'''Compile kernel source code'''
Use this [[Linux Kernel 2.6.35.y|tutorial]] (Kernel) and this [http://labs.igep.es/index.php/The_IGEP_X-loader other] (IGEPxloader) to install Linaro Headless (or Poky) with your custom kernel in SD card. You can compile the IGEPxloader, but is not necessary.<br>
==== WIFI ====
'''Compile kernel source code'''
Use this [[Linux Kernel 2.6.35.y|tutorial]] (Kernel) and this [http://labs.igep.es/index.php/The_IGEP_X-loader other] (IGEPxloader) to install Linaro Headless (or Poky) with your custom kernel in SD card. You can compile the IGEPxloader, but is not necessary.<br>
=== TP65950 PCM VSP ===
Power down (active low). In the powerdown state, only the digital I/O buffers and I2C interface remain active. A high level selects the normal operating mode. A low level selects the powerdown mode.<br>
It was tested using alternate peripherals like UARTs and GPIOs.
{| cellspacing="1" cellpadding="1" border="1" align="center" width="200"
'''Compile kernel source code'''
Use this [[Linux Kernel 2.6.35.y|tutorial]] (Kernel) and this [http://labs.igep.es/index.php/The_IGEP_X-loader other] (IGEPxloader) to install Linaro Headless (or Poky) with your custom kernel in SD card. You can compile the IGEPxloader, but is not necessary.<br>
= Edit mux =
<pre>; Setup the Kernel console params
;console=ttyS2,115200n8 </pre>
You can test new configuration using [[How to use UARTs|this tutorial]]<br>
=== GPIO in J990 ===
