Difference between revisions of "IGEP0040HardwareRABugs"
From IGEP - ISEE Wiki
m |
m (→BUG ALL_01: (IMPORTANT) Missing 1V8 26MHz Oscillator) |
||
Line 1: | Line 1: | ||
=== BUG ALL_01: (IMPORTANT) Missing 1V8 26MHz Oscillator === | === BUG ALL_01: (IMPORTANT) Missing 1V8 26MHz Oscillator === | ||
− | '''INFO:''': This clock is not mounted at proto first assembly. It is necessary to enable some PLL and other PXA2128 clock | + | '''INFO:''': This clock is not mounted at proto first assembly. It is necessary to enable some PLL and other PXA2128 clock requirements. |
'''WORKAROUND:''' Installed a 1V8 26MHz Oscillator with 50 ppm from "XTAL affaire box" | '''WORKAROUND:''' Installed a 1V8 26MHz Oscillator with 50 ppm from "XTAL affaire box" |
Revision as of 18:38, 6 August 2015
Contents
BUG ALL_01: (IMPORTANT) Missing 1V8 26MHz Oscillator
INFO:: This clock is not mounted at proto first assembly. It is necessary to enable some PLL and other PXA2128 clock requirements.
WORKAROUND: Installed a 1V8 26MHz Oscillator with 50 ppm from "XTAL affaire box"
- Mount O1, R106, C276
RESULT:
- Tested with oscilloscope VCXO_IN signal
BUG ALL_02: Marvell flat connector mounted
WORKAROUND: Use a 1.27 mm header instead to allow get access to signals easier
- Mount JTAGB
- Umount JTAG
BUG ALL_03: PRI_TRST is low, has no PU
WORKAROUND: Use PU resistor to V_1P8 to pull high this signal. This resistors should be added to Layout. Need to check if this bug is important
BUG ALL_04: (IMPORTANT) Remove power bad resistors
INFO:: This resistors disables power sequence from power switch and LDOs to PXA2128
WORKAROUND: Disable this SMARC feature
- Umount: R971, R972, R973, R974 and R975
BUG ALL_05: V_3P3 LDO has no delay sequence
INFO:: Need to check if this bug is important