Difference between revisions of "Getting started with IGEP SMARC EXPANSION"
From IGEP - ISEE Wiki
(→Overview) |
|||
Line 19: | Line 19: | ||
− | + | == Remote connection via Serial interface == | |
+ | |||
+ | === Overview === | ||
+ | |||
+ | Serial header (J801) lets you debug system with an USB to 3V3 TTL level serial like TTL-232R-3V3 converter from [http://www.ftdichip.com/Products/Cables/USBTTLSerial.htm FTDI] or compatible reference. The TTL-232R-3V3 converter has 6 pins and IGEP SMARC EXPANSION add a 7th way (3v3 power). The next image shows how to connect it: | ||
+ | <br><br> | ||
+ | {| cellspacing="1" cellpadding="1" width="150" border="1" align="center" | ||
+ | |- | ||
+ | | [[Image:SERIAL_CABLE_BASE0040.JPG|600px]]<br> | ||
+ | |} | ||
+ | <br> | ||
+ | |||
+ | === Setting up connection === | ||
+ | |||
+ | Open the serial on your PC using your preferred serial communications program (minicom) and configure the port as follows: | ||
+ | |||
+ | * 115200 | ||
+ | * 8N1 | ||
+ | * no flow control (either software or hardware) | ||
+ | |||
+ | Open the serial port and the debug shell prompt should appear. | ||
+ | |||
+ | A detailed guide on how to connect via serial debug port can be found by following this link: [[Using serial debug port to communicate]] |
Revision as of 11:40, 21 March 2017
|
|
Contents
Overview
This is the 1/3 chapter of the Getting Started with IGEP SMARC EXPANSION Tutorial Guide. In this first chapter, we will learn:
- Connect some peripherals, including monitor and USB peripherals.
- Boot the board.
Upon completion, you will be ready to continue with chapter 2/3 that explains more advanced tasks.
Remote connection via Serial interface
Overview
Serial header (J801) lets you debug system with an USB to 3V3 TTL level serial like TTL-232R-3V3 converter from FTDI or compatible reference. The TTL-232R-3V3 converter has 6 pins and IGEP SMARC EXPANSION add a 7th way (3v3 power). The next image shows how to connect it:
600px |
Setting up connection
Open the serial on your PC using your preferred serial communications program (minicom) and configure the port as follows:
- 115200
- 8N1
- no flow control (either software or hardware)
Open the serial port and the debug shell prompt should appear.
A detailed guide on how to connect via serial debug port can be found by following this link: Using serial debug port to communicate