Getting started with IGEP PARIS
From IGEP - ISEE Wiki
This is the 1/3 chapter of IGEP PARIS Expansion Tutorial Guide.
In this first chapter, we will learn how to connect some expansion peripherals.
In this tutorial we are going to use the following peripherals:
- IGEP COM MODULE
- IGEP PARIS Expansion
- 5V DC power supply with a minimum of 3A current capacity
- TFT touch screen Seiko 7"
- Network cable
- USB keyboard and a mouse (optional)
- Li-on battery with 3V3 (optional)
- DB9 connector
Connect IGEP PARIS Expansion with IGEP COM MODULE/NEUTRON Board
The IGEP PARIS Expansion connects to the IGEP COM MODULE/NEUTRON Board through J1 and J4 connectors. Just take a look on the figure to mount it:
Enable IGEP PARIS Expansion support
IGEP Yocto Firmware comes with IGEP PARIS Expansion support. However open igep.ini, you can do this checking following kernel cmdline parameter:
buddy=base0010 buddy.revision=B ;buddy=ilms0015
Remote connection via Ethernet
|If you aren't using a Linux operating system, use IGEP SDK Virtual Machine to connect to the board|
In your Host Machine, open a terminal sessions set up an Ethernet alias for your network interface,
$ sudo ifconfig eth0:0 192.168.5.10
Connect to the board using the SSH protocol
$ ssh firstname.lastname@example.org
An empty password for root user should work to access to the shell prompt.
You have successfully completed this chapter of the guide.
|If you have any question, don't ask to ask at the IGEP Community Forum or the IGEP Community Chat|