0
edits
Changes
From IGEP - ISEE Wiki
no edit summary
userspace. LEDs appear in /sys/class/leds/ and you can turn on and off with following commands:
<pre>
$ echo 1 > /sys/class/leds/igep\:red\:led1/brightness
$ echo 1 > /sys/class/leds/igep\:red\:led0/brightness
$ echo 0 > /sys/class/leds/igep\:red\:led1/brightness
$ echo 0 > /sys/class/leds/igep\:red\:led0/brightness
</pre><pre>
$ echo 1 > /sys/class/leds/igep\:green\:led1/brightness
$ echo 1 > /sys/class/leds/igep\:green\:led0/brightness
$ echo 0 > /sys/class/leds/igep\:green\:led1/brightness
$ echo 0 > /sys/class/leds/igep\:green\:led0/brightness
</pre>
The base has two user (red/blue). Can't use them in the same time.
<pre>
$ echo 1 > /sys/class/leds/base\:blue\:led0/brightness
$ echo 1 > /sys/class/leds/base\:red\:led0/brightness
$ echo 0 > /sys/class/leds/base\:blue\:led0/brightness
$ echo 0 > /sys/class/leds/base\:red\:led0/brightness
</pre>
A detailed guide on how use GPIO-LEDS can be found by following this link: [[How to handle the gpio-LED]]
== CAN BUS ==
'''under construction'''
== How to use UART (RS485) ==
== CAN BUS ==
'''under construction'''
== Audio ==
'''under construction'''
== Boot SATA ==
'''under construction'''
== Boot emmc ==
'''under construction'''
== Install firmware emmc ==
'''under construction'''
== EEPROM ==
'''under construction'''
== SPINOR ==
'''under construction'''
== IO expansion ==
'''under construction'''
== wifi ==
'''under construction'''
== HDMI resolution ==
'''under construction'''
== modem USB ==
{{Template:Navigation/IGEP Technology Guides/What can I do/Ending}}
[[Category:IGEP Technology Devices Guides]]
