What can I do with IGEP RADAR SENSOR ORION
From IGEP - ISEE Wiki
|
|
Interfacing with the sensor
You can control the sensor and get IF signal directly or through included ADC by means of different expansion connectors:
Expansion connector-I
Expansion connector JC1 is intended for control and monitoring of internal radar sensor ORION signals.
JC1 pin-out
NOMENCLATURE
Function names marked with gray shading indicates that are available only on demand
PIN: PIN NUMBER OF THE CONNECTOR. SUBINDEX MEANING:
o PW: Power Line
o DIG: CMOS DIGITAL SIGNAL PORT 1V8 LOGIC LEVELS
o DIG3: CMOS DIGITAL SIGNAL PORT 3V3 LOGIC LEVELS
o DIG5: CMOS DIGITAL SIGNAL PORT 5V LOGIC LEVELS
o ANA: ANALOG PORT
o NC: PIN NOT CONNECTED
- <span style="mso-tab-count: 1" />NAME: FUNCTION OF THIS PORT. SUPERINDEX MEANING:
o (L): ACTIVE LOW LEVEL
o (H): ACTIVE HIGH LEVEL
LEVEL: IS THE NOMINAL VOLTAGE LEVEL
MODE 0: IS THE MODE 0 function pin name of OMAP microcontroller
MAX: IS THE ABSOLUTE MAXIMUM ALLOWED VOLTAGE LEVEL ON THIS PIN (PERMANENT DAMAGE IF HIGHER VOLTAGE)
FUNCTION: DESCRIPTION OF PIN SIGNAL
o (1): ISEE INTERNAL USE TEST PIN. AVAILABLE ONLY ON DEMAND<span lang="EN-US" style="mso-bidi-font-family: TimesNewRoman" />
o (2): INPUT when power supply is applied to radar board. OUTPUT in other case.
IGEPv2 Expansion
A single expansion connector, JC2, is enough to adapt IGEPv2 processor board to the radar sensor ORION.
JC2 pin-out
IGEP COM MODULE Expansion
2 expansion connectors are needed to interface radar sensor ORION with processor board IGEP COM MODULE: JC3 & JC4
JC3 pin-out
Expansion connector JC4
You have successfully completed this chapter of the guide.
|
|
If you have any question, don't ask to ask at the IGEP Community Forum or the IGEP Community Chat | 
|
