Changes

What can I do with IGEP RADAR SENSOR ORION

696 bytes added, 08:52, 29 July 2013

no edit summary

= Interfacing with the sensor =

You can control the sensor and get IF signal directly or through included ADC by means of different expansion connectors.  The included DDS modulator can be programmed with a set of different modulation ramps through the SPI link available on the expansion connectors. The IF signal can be obtained directly in analog format or already sampled by the included ADC through the same SPI link used to program the DDS modulator. The following paragraphs give you the pin-out of the different expansion connectors:

= Expansion connector-I =

[[Image:Table orion JC2.jpg]]

= IGEP COM MODULE Expansion<br> = 2 expansion connectors are needed to interface radar sensor ORION with processor board IGEP COM MODULE: JC3 &amp; JC4  <br>  == JC3 pin-out == [[Image:Table orion JC3.jpg]]  == Expansion connector JC4 == [[Image:Table orion JC4.jpg]]   

2 expansion connectors are needed to interface radar sensor ORION with processor board IGEP COM MODULE: JC3 &amp; JC4

= Applications =

== JC3 pin-out ==You can see a complete list of applications of the radar sensor ORION combined with a processor board on this link: [http://labs.isee.biz/index.php/What_can_I_do_with_IGEP_RADAR_LAMBDA#Radar_Applications:_Examples RADAR APPLICATIONS]<br>

[[Image:Table orion JC3.jpg]]<br>

== Expansion connector JC4 ==<br> <br>

[[Image:Table orion JC4.jpg]]<br>

{{Template:Navigation/IGEP Technology Guides/What can I do/Ending}}

[[Category:IGEP Technology Devices GuidesIGEP_Technology_Devices_Guides]]

• ← Older edit

Carles Recasens

646

edits