4,199
edits
Changes
From IGEP - ISEE Wiki
m
→Flash USB memory
== Flash USB memory ==
uSD firmware contains the roofs available to write the firmware to the flash memory.
*Enter to the /opt/firmware and run the igep-flash script :
<pre>igep-flash --image /opt/firmware/core-image-validation-igep0033-20130916081322.rootfs.tar.bz2</pre>
When finish, power off your board, unplug the micro-SD card and power on the board. That's all, enjoy the new firmware running from the flash memory.
*'''NOTE:''' You can speed up flash procedure. By default the flash script runs the nandtest command to mark bad blocks, this can take a long time and in most cases is not necessary, you can speed up the flash procedure running the script as follows:
<pre>igep-flash --image /opt/firmware/core-image-validation-igep0033-20130916081322.rootfs.tar.bz2 --skip-nandtest </pre>
== How to use audio HDMI ==