4,199
edits
Changes
From IGEP - ISEE Wiki
m
When finish, power off your board, unplug the micro-SD card and power on the board. That's all, enjoy the new firmware running from the flash memory.
'''NOTE:''' You can speed up flash procedure. By default the flash script runs the nandtest command to mark bad blocksWhen finish, power off your board, this can take a long time mount J101 jumper and in most cases is not necessarypower on the board. That's all, you can speed up enjoy the flash procedure new firmware running from the script as follows: <pre>igep-flash --machine igep0033 --skip-nandtest --image /opt/firmware/core-image-validation-igep0033-20130916081322.rootfs.tarmemory.bz2</pre>
→Flash internal memory
uSD firmware contains the roofs available to write the firmware to the flash memory.
*Enter to the /opt/firmware and run the Use igep-flash script to write the internal memory:
<pre> igep-flash --machine igep0033 --image /opt/firmware/core-image-validation-igep0033-20130916081322.rootfs.tar.bz2 </pre>
== How to use audio HDMI ==
