4,199
edits
Changes
m
Run the following commands:
sudo ifconfig eth0 down
sudo ifconfig eth0 192.168.5.10 up
'''NOTE:''' You should have the usbnet module available for your Linux kernel. On most distributions, this is the case by default. If this is not the case for your distribution, you will need to enable USB networking support in the kernel. If you build your own kernel then you want 'CDC Ethernet support' in USB Network adaptors. IGEP SDK Virtual Machine has this module enabled.
usb0 eth0:0 Link encap:Ethernet HWaddr 6608:cc00:f227:bead:510c:b6 ad inet addr:192.168.75.10 Bcast:1920.1680.70.255 0 Mask:255.255.255.0 inet6 addr: fe80::64cc:f2ff:febe:51b6/64 Scope:Link
RX packets:14 errors:0 dropped:0 overruns:0 frame:0
TX packets:44 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:2496 (2.4 KB) TX bytes:8794 (8.7 KB)
→Linux
If you are running Linux in your PC, open a Terminal session and set the IP of the Ethernet interface in which IGEP is connected (for example eth0):
*In the file /etc/network/interfaces, you should add:
<pre>iface usb0 eth0 inet dhcp</pre> *Plug an USB Type-A to USB Type-A mini cable between your host PC and the USB OTG from IGEP deviceiface eth0:0 inet staticaddress 192.168. Use a powered USB Hub if you use IGEP COM MODULE or PROTON Board5. 10*If you use IGEP SDK VM you need to attach the [http://labsnetmask 255.isee255.biz/index255.php0</IGEP_SDK_Virtual_Machine#Attach_removable_devices_to_Virtual_Machine removable device] RNDIS driver. pre>
*Type in a terminal:
<pre>sudo ifup usb0eth0:0</pre>
*Revise that:
<pre>jdoe@ubuntu ~ $ ifconfig
...
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
...</pre>
*Connect to IGEP device
jdoe@ubuntu ~ $ ssh root@192.168.75.1 The authenticity of host '192.168.7.1 (192.168.7.1)' can't be established. ECDSA key fingerprint is 80:be:2d:b6:fe:b1:09:c3:3b:ac:0f:1d:f2:43:f2:20. Are you sure you want to continue connecting (yes/no)? yes Warning: Permanently added '192.168.7.1' (ECDSA) to the list of known hosts.
root@igep00x0:~# uname -a
Linux igep00x0 2.6.37 #1 Thu Jul 19 09:07:47 CEST 2012 armv7l GNU/Linux