1,381
edits
Changes
→Mount the eMMC partitions
=== Mount the eMMC partitions ===
Use the command mount if automount is not enabled as
<pre>mount /dev/mmcblk0p1 /mnt/p1
umount /mnt/p2
</pre>
Reboot the board (remember set the board dips in the right boot setup)
== Special Warning about MicroSD Card and eMMc ==
The microsd card uses the interface mmc as the eMMC in some cases as when you boot from your microsd card the lsblk command can show you two mmc devices:
/dev/mmcblk0
/dev/mmcblk1
Normally the 0 is the boot device (from where you boot), if you use the microsd card for boot : /dev/mmcblk0 and the eMMC is the /dev/mmcblk1 but if you boot from the eMMC and insert the microsd card then the eMMC is /dev/mmcblk0 and the microsd card be /dev/mmcblk1
= References =