0
edits
Changes
From IGEP - ISEE Wiki
m
no edit summary
Enter to the IGEP Processor Board using 'root' as login name and an 'empty password', enter to the /opt/firmware and run the igep-flash script
<pre>igep-flash --image /opt/firmware/demo-image-sato-igep00x0.tar.bzbz2</pre>
When finish, power off your board, unplug the micro-SD card and power on the board. That's all, enjoy the new firmware running from the flash memory.
'''NOTE:''' You can speed up flash procedure. By default the flash script runs the nandtest command to mark bad blocks, this can take a long time and in most cases is not necessary, you can speed up the flash procedure running the script as follows:
<pre>igep-flash --image /opt/firmware/demo-image-sato-igep00x0.tar.bz bz2 --skip-nandtest </pre>
[[Category:Software_distributions]]
