0
edits
Changes
From IGEP - ISEE Wiki
m
{{Message/Information Message|title=TITLE|message=This How-To was tested with an Ubuntu 10.04 host machine, but most of the contents are valid also for other GNU/Linux distributions.
There is no guarantee that this will work on other distributions.}}
cd poky-firmware-3.3.1-11/
no edit summary
{{Message/Information Message|title=TITLE|message=This How-To was tested with an Ubuntu 10.04 host machine, but most of the contents are valid also for other GNU/Linux distributions.
There is no guarantee that this will work on other distributions.}}
<section begin=IGEPv2 />
<section begin=IGEP_COM_MODULE />
<section begin=IGEP_COM_PROTON />
Start session in a Linux PC. The first thing you'll do is download latest firwmare from the ISEE site.
<section end=IGEP_COM_PROTON />
Next, open we will use the application 'tar' to untar (uncompress) the downloaded file. Open a Terminal session and go to untar the firmware folder where you have just donwloaded and enter to the directoryyour downloaded file. Then type:
tar xzf poky-firmware-3.3.1-11.tar.gz
Next, you can enter the extracted directory: cd poky-firmware-3.3.1-1/ '''Create a MicroSD Card''' Now, lets create the MicroSD card with the latest firmware. Before it, you have to know '''which 'device' is the MicroSD listed in the /dev/ directory''', a directory where the detected devices are listed by the Linux system. To '''know the device name''', follow this instructions: '''Insert your SD MicroSD card ''' into the Linux host machine (the machine where you have downloaded the firmware). In your Terminal session, run the following '''system command''': dmesg This instruction will prompt all the '''system traces'''. If your MicroSD card has actually been detected by the system, '''the last lines of that prompt''' will correspond to the MicroSD card detection and mounting. Check the '''MicroSD name and path''', for example: /dev/sdb and remember it. Now you can '''run the following commandscript''' in the folder you have just extracted, and you will have to add some parameters. In your Terminal session, type:
./poky-media-create --mmc [device] --binary poky-image-sato-igep00x0-[timestamp].tar.gz --machine [machine]
where:
* '''[device] ''' is the SD card device name, for example: /dev/sdb* '''[timestamp] ''' the parameter --binary is actually the timestamp name of another .tar.gz compressed filethat you have already extracted in the previous steps. If you want to auto-complete the [timestamp] parameter, press TAB in the ''timestamp'' when writing the instruction and the system will write the name of the file automatically.* '''[machine] ''' is the machine name, options isare:
<section begin=IGEPv2 />** igep0020 , for IGEPv2<section end=IGEPv2 />
<section begin=IGEP_COM_MODULE />** igep0030 , for IGEP COM MODULE<section end=IGEP_COM_MODULE />
<section begin=IGEP_COM_PROTON />** igep0032 , for IGEP COM PROTON<section end=IGEP_COM_PROTON />
This instruction will last a few minutes. When the process ends, you will have a '''MicroSD card with the latest software''' on it.
Finally plug the MicroSD card into IGEP Processor Board and power up your board.
<section end=IGEPv2 /><section end=IGEP_COM_MODULE /><section end=IGEP_COM_PROTON />
