Changes

}}

This is the 1/3 chapter of the Getting Started with IGEPv2 Tutorial Guide. In this first chapter, we will learn :

__TOC__

In this tutorial we are going to use the following peripherals:

* PC

The following video illustrates the getting started process. You will see how to connect some peripherals and power up the board.

{{#ev:youtube|jtHL6JVo7kA|500}}

</div>

The board will connect to your DVI monitor via its HDMI connector. You can use a HDMI/DVI-D cable to connect the board to the monitor. Your monitor should be able to support 1024 x 768 @ 60 Hz, which is the default resolution used by the firmware.

omapfb.mode=dvi:hd720-16@60

You may now plug the Ethernet cable into the 10/100 Ethernet jack of the board to get network access. The default firmware configures the Ethernet device with static ip address (192.168.5.1).

The USB Host of the board is ONLY USB High speed (480Mbit/s). You will need a powered USB hub 2.0 to connect to most USB devices.

Now, connect an USB hub to the USB Host and plug your keyboard and mouse into the hub.

With all the peripherals attached, plug in the wall adapter (5V DC) and power on your board. You will see a few lights flash, see how to red leds light up and after a few seconds may light up only a fixed green led. The sequence will be different based on software version.

You can use the mouse and the keyboard to dive into the desktop.

{{Message/Information Message|title=|message=If you aren't using a Linux operating system, use [http://labs.isee.biz/index.php/IGEP_SDK_Virtual_Machine IGEP SDK Virtual Machine] to connect to the board}}