Changes

Getting started with IGEP SMARC PXA2128

461 bytes added, 12:42, 5 September 2018

no edit summary

$ wget http://downloads.isee.biz/pub/relaunch/rootfs/ubuntu/xenial/ubuntu-xenial-armhf-igep-base-no-version.tgz

 

Once we have downloaded the software, i'ts necessary compile linux kernel and install the modules in your Rootfs, the tutorial is in the following link:

 

[[Linux Kernel 4.9.y]]

 

'''2. Burn Software  in SD Card'''

With a general processor all start with MLO file and U-Boot.img. Also it is the same procedure for Freescale- NXP. If you want to see how to create these files follow [[The bootloader U-Boot|this]].

Next step is that once the processor is initialized,call theLinux kernel making the execution of  your operative system available.

linux kernel making Finally your OS runs and you can initialize the execution of  your operative system available.board correctly 

Finally your OS runs and you can initialize the board correctly [[File:How_to_SD.PNG|866x372px]]

To boot from MicroSD Card follow this [[How to boot from MicroSD Card|link.]]

 

 

I'ts necessary compile linux kernel and install the modules in your Rootfs, the tutorial is in the following link:

 

[[Linux Kernel 4.9.y]]

'''3. Booting'''

You can test your new microSD card with a Serial client such as PuTTy. [[Using serial debug port to communicate|Here]] is an explanation about how to configure it.

 

(Note that speed should be configured to 115200 bauds).

 

If you already have configured it or you are using another Serial client and you have connected the Serial cable to the IGEP0034 board, then you are ready to test your microSD.

 

Insert the microSD in your IGEP0034 board and power up the board.

• ← Older edit

Sergi Palacios

34

edits