Getting Started with IGEP0030 board
IGEP0030
|
| Getting started with IGEP0030 |
| This page is a starting point for all products of the IGEP0030 family such IGEP COM MODULE. |
| Overview | ||
 | ||
| 1) Connect USB OTG cable to a PC | ||
| 2) Log in IGEP0030 via Wifi | ||
This first chapter describes how to boot IGEP030 and also gives some basic instructions about how to connect some peripherals.
Overview
Important note - Please read these documents before continuing with this article:
- Official IGEP0030 Hardware Reference Manual from ISEE
|
It is highly recommended to update your pre-installed software image to a recent release to ensure you have the latest features and bug fixes. |
|---|
Adding peripherals
USB OTG
The on-board HS USB OTG port is used as the default power input for IGEP0030 standalone operating mode. We can power up the IGEP0030 via the on-board USB OTG port, and we only need to use a USB cable (USB A type plug to mini B type plug) between the IGEP0030 board and your host machine.
Booting up
Once the board is powered up and running, we will get Ethernet connectivity over the same USB cable (USB Ethernet Gadget/RNDIS driver) or via wireless.
By default, the IGEP0030 usb interface will have the IP address 192.168.7.2, and the wireless interface comes with WLAN_IGEP as ESSID and 192.168.6.1 as IP address.