Getting started with IGEP MODULE
From IGEP - ISEE Wiki
Revision as of 12:25, 16 November 2010 by Eballetbo (talk | contribs) (Created page with '== Introduction == This page describes how to use the USB device (or OTG) port of your OMAP3 IGEP module to communicate with your PC. The HS USB OTG port is used as the default…')
Contents
Introduction
This page describes how to use the USB device (or OTG) port of your OMAP3 IGEP module to communicate with your PC.
The HS USB OTG port is used as the default power input,
By default the module interface will have the IP address 192.168.7.2
Linux Host USB Network Configuration
You should have the usbnet module available for your Linux kernel. On most distributions, this is the case by default. If this is not the case for your distribution, you will need to enable USB networking support in the kernel. If you build your own kernel then you want 'CDC Ethernet support' in USB Network adaptors.
Ubuntu 10.04 LTS Lucid Lynx
In the file /etc/network/interfaces, you should add a section which looks like this:
auto usb0 iface usb0 inet static address 192.168.7.1 network 192.168.7.0 netmask 255.255.255.0 broadcast 192.168.7.255 gateway 192.168.7.1
Connect to board using ssh
$ ssh -l root 192.168.7.2 The authenticity of host '192.168.7.2 (192.168.7.2)' can't be established. RSA key fingerprint is 9d:0e:ba:02:2a:76:e4:5f:d1:c1:9b:2d:85:6c:83:d4. Are you sure you want to continue connecting (yes/no)? yes Warning: Permanently added '192.168.7.2' (RSA) to the list of known hosts. root@192.168.7.2's password: [enter] (no password) root@igep0030:~#