Getting started with IGEP BERLIN
|
|
Contents
Overview
This is the 1/3 chapter of IGEP BERLIN Expansion Tutorial Guide.
In this first chapter, we will learn how to connect some expansion peripherals.
Requirements
In these tutorials we are going to need the following components:
- IGEP COM PROTON or IGEP COM MODULE.
- 5V DC power supply with a minimum of 3A current capacity.
- Seiko 7" screen if you need a touch screen.
- Ethernet cable for network communications.
- A monitor compatible with DVI-D.
- An USB keyboard and a mouse (optional).
- 4 pin connector for CAN Bus with another IGEP Board with CAN peripheral to follow CAN Bus communication tutorial.
- SIM card with an antenna to follow Telit modem tutorial.
- Composite video cable, composite video output peripheral (PAL or NTSC) and a screen to follow TVP5151 tutorial.
- Li-on battery with 3V3 (optional).
- A PC.
Getting started
Ethernet Network cable
Plug an Ethernet cable between IGEP BERLIN and your client machine (or any other network device with Ethernet connectivity). Use J3 connector with IGEP PROTON and J1001 connector with IGEP MODULE.
Connect IGEP BERLIN Expansion with IGEP COM MODULE/NEUTRON Board
The IGEP BERLIN Expansion connects to the IGEP COM MODULE/NEUTRON Board through J1 and J4 connectors. Just take a look on the figure below to mount it:
Connect IGEP BERLIN Expansion with IGEP COM PROTON Board
The IGEP BERLIN Expansion connects to the IGEP COM PROTON Board through J1, J4, J9 and J8 connectors. Just take a look on the figure below to mount it:
You have successfully completed this chapter of the guide.
|
If you have any question, don't ask to ask at the IGEP Community Forum or the IGEP Community Chat |