4,199
edits
Changes
m
*eth0 − 192.168.5.1 *eth0:0 − assigned via dhcp. This Ethernet network configuration is really useful when you work using a Linux operating system like IGEP SDK Virtual Machine. Because you use eth0 device to communicate easily with your board and eth0:0 device to get Internet acces using dhcp protocol. But some scenarios this network configuration is not useful, for example: if you use a non-Linux operating system, connect to two IP private range interfaces is not simple. This How-to can be useful to
IP private range 192(Make diagram one: IGEP and Linux defualt communication.168.5.X is not usedDiagram 2 IGEP and other SO alternative configuration)
→Configure a static IP using the same private network range
== Configure a static IP using the same private network range ==
'''under construction'''
IGEP Firmware Yocto uses the following Ethernet network configuration (IP addresses)
= Backup your flash memory =